user manual

13 – Command Reference
Set Config Security
59183-01 A 13-67
A
Set Config Security
Configures the security database for the automatic saving of changes to the active
security set and fabric binding. The changes you make with this command are not
retained when you reset or power cycle the switch unless you save them using the
Config Save command.
Authority Admin session and a Config Edit session
Syntax set config security
This command initiates an editing session in which to change the security
database configuration. The system displays each parameter one line at a time
and prompts you for a value. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter “q” or "Q" to end
the editing session. Table 13-15 describes the security configuration parameters.
Examples The following is an example of the Set Config Security command:
SANbox #> admin start
SANbox (admin) #> config edit
SANbox (admin-config) #> set config security
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
NOTE: This command requires the Fabric Security license key. To purchase a
license key, contact your authorized maintenance provider or
authorized reseller. Use the Feature command to install a license key.
Table 13-15. Security Configuration Parameters
Parameter Description
AutoSave Enables (True) or disables (False) the saving of changes
to active security set in the switch’s permanent memory.
The default is True.
FabricBindingEnabled Enables (True) or disables (False) the configuration and
enforcement of fabric binding on all switches in the fabric.
Fabric binding associates switch worldwide names with a
domain ID in the creation of ISL groups.