user manual

13 – Command Reference
Set Config Port
59183-01 A 13-61
A
Set Config Port
Sets the port configuration parameters for one or more ports. The changes you
make with this command are not retained when you reset or power cycle the
switch unless you save them using the Config Save command.
Authority Admin session and a Config Edit session
Syntax set config port [port_number]
or
set config ports [port_number]
Keywords port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Enter “q” to end the configuration for one port, or “qq” to end the configuration for
all ports. Table 13-14 describes the port configuration parameters.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter “q” to end the
configuration. Table 13-14 describes the port configuration parameters.
Table 13-14. Port Configuration Parameters
Parameter Description
AdminState Port administrative state:
 Online – Activates and prepares the port to send data.
This is the default.
 Offline – Prevents the port from receiving signal and
accepting a device login.
 Diagnostics – Prepares the port for testing and prevents
the port from accepting a device login.
 Down – Disables the port by removing power from the
port lasers.
LinkSpeed Transmission speed:
 1/2/4-Gbps Ports: 1-Gbps, 2 Gbps, 4-Gbps, or Auto. The
default is Auto.
 10-Gbps Ports: 10-Gbps or Auto. The default is Auto.