user manual

13 – Command Reference
Group
59183-01 A 13-27
A
list
Displays a list of all groups and the security sets of which they are members. This
keyword is available without an Admin session.
members [group]
Displays all members of the group given by [group]. This keyword is available
without an Admin session.
remove [group] [member_list]
Remove the port/device worldwide name given by [member] from the group given
by [group]. Use a <space> to delimit multiple member names in [member_list]
rename [group_old] [group_new]
Renames the group given by [group_old] to the group given by [group_new].
securitysets [group]
Displays the list of security sets of which the group given by [group] is a member.
This keyword is available without an Admin session.
type [group]
Displays the group type for the group given by [group]. This keyword is available
without an Admin session.
Notes Primary and secondary secrets are not included in a switch configuration backup.
Therefore, after restoring a switch configuration, you must re-enter the primary
and secondary secrets. Otherwise, the switch will isolate because of an
authentication failure.
Refer to the “Securityset” command on page 13-56 for information about
managing groups in security sets.
Binding
(ISL Groups)
Domain ID of the switch to which to bind the ISL group mem-
ber worldwide name. This option is available only if
FabricBindingEnabled is set to True using the
Set Config Security command. 0 (zero) specifies no binding.
Table 13-4. Group Member Attributes (Continued)
Attribute Description