user manual

11 – Event Log Configuration
Displaying the Event Log
11-2 59183-01 A
S
11.2
Displaying the Event Log
Enter the Show Log command to display the event log. Each message has the
following format:
[ordinal][time_stamp][severity][message_ID][source][message_text]
[ordinal]–A number assigned to each message in sequence since the
last time the alarm history was cleared.
[time_stamp]–The time the alarm was issued in the format
day month hh:mm:ss.ms UTC yyyy. This time stamp comes from the switch
for events that originate with the switch, and from the workstation for events
that originate with Enterprise Fabric Suite 2007.
[severity]–The event severity: A–Alarm, C–Critical, W–Warning,
I–Informative.
[message_ID]–A number that identifies the message using the following
format: category.message_number
[source]–The program module or application that generated the event.
Sources include Zoning, Switch, PortApp, EPort, Management Server.
Alarms do not include the source.
[message_text]–The message text
The following is an example of the Show Log command:
SANbox #> show log
[327][day month date time year][I][Eport Port:0/8][Eport State=
E_A0_GET_DOMAIN_ID]
[328][day month date time year][I][Eport Port: 0/8][FSPF PortUp state=0]
[329][day month date time year][I][Eport Port: 0/8][Sending init hello]
[330][day month date time year][I][Eport Port: 0/8][Processing EFP, oxid= 0x8]
[331][day month date time year][I][Eport Port: 0/8][Eport State = E_A2_IDLE]
[332][day month date time year][I][Eport Port: 0/8][EFP,WWN= 0x100000c0dd00b845,
len= 0x30]
[333][day month date time year][I][Eport Port: 0/8][Sending LSU oxid=0xc:type=1]
[334][day month date time year][I][Eport Port: 0/8][Send Zone Merge Request]
[335][day month date time year][I][Eport Port: 0/8][LSDB Xchg timer set]
You can also filter the event log display with the Show Log Display command and
customize the messages that display automatically in the output stream.
 Filtering the Event Log Display
 Controlling Messages in the Output Stream