user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
4 – Command Reference
Command Syntax
4-58 SN0054659-00 A
S
Show iSNS
Displays iSNS configuration information for the specified iSCSI port. If you do not
specify the port, this command displays the iSNS configuration information for
both iSCSI ports.
Authority None
Syntax show isns [port_num]
Keywords [port_num]
Specifies the iSCSI port number whose iSNS configuration you want to display.
Examples Show iSNS command example:
QRouter (admin) #> show isns
iSNS Information
------------------
iSCSI Port 1
iSNS Enabled
IPv6 Address fe80::21b:21ff:fe06:d517
TCP Port No. 3205
iSCSI Port 2
iSNS Disabled
IP Address 0.0.0.0
TCP Port No. 3205