user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
4 – Command Reference
Command Syntax
4-56 SN0054659-00 A
S
Show iSCSI
Displays iSCSI information for the specified port. If you do not specify the port, this
command displays both ports.
Authority None
Syntax show iscsi [port_num]
Keywords [port_num]
Specifies the number of the iSCSI port to display.
Examples Show iSCSI port command example:
QRouter (admin) #> show iscsi
iSCSI Port Information
------------------------
iSCSI Port 1
Port Status Enabled
Link Status Up
iSCSI Base Name
iqn.2004-08.com.qlogic:isr-6142.0608a00471.0
MAC Address 00-c0-dd-0c-8b-e2
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway IP Address 0.0.0.0
Firmware Revision No. 3.00.02.44
No. of Open Connections 0
Target TCP Port No. 3260
MTU Size Normal
Window Size 32768
Window Scaling Enabled
Window Scaling Factor 1
Current Port Speed 1Gb/FDX
Programmed Port Speed Auto
Header Digests Enabled
Data Digests Enabled
Max Burst 262144
Max First Burst 65536
VLAN Disabled
IPv6 Address 1 ::
IPv6 Address 2 ::