user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
4 – Command Reference
Command Syntax
4-52 SN0054659-00 A
S
Show FC
Displays Fibre Channel port information for the specified port. If you do not specify
the port, it displays both ports.
Authority None
Syntax show fc [port_num]
Keywords [port_num]
Specifies the number of the FC port to display.
Examples Show FC command example:
QRouter (admin) #> show fc
FC Port Information
---------------------
FC Port 1
Port Status Enabled
Link Status Up
Current Link Rate 2Gb
Programmed Link Rate Auto
WWNN 20:00:00:c0:dd:0c:8b:e2
WWPN 21:00:00:c0:dd:0c:8b:e2
Port ID 02-02-ef
Firmware Revision No. 3.03.07
Frame Size 2048
Execution Throttle 64
Connection Mode Loop
Programmed Connection Option Loop Preferred
FC Port 2
Port Status Enabled
Link Status Up
Current Link Rate 2Gb
Programmed Link Rate Auto
WWNN 20:00:00:c0:dd:0c:8b:e3
WWPN 21:00:00:c0:dd:0c:8b:e3
Port ID 02-06-ef
Firmware Revision No. 3.03.07
Frame Size 2048
Execution Throttle 64
Connection Mode Loop
Programmed Connection Option Loop Preferred