user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
4 – Command Reference
Command Syntax
4-34 SN0054659-00 A
S
Set
Configures general router parameters as well as parameters that are specific to
the Fibre Channel, iSCSI, and management ports.
Authority Admin session
Syntax set
chap
fc [port_num]
features
Iscsi [port_num]
Isns [port_num]
mgmt
ntp
properties
snmp
system
Keywords chap
Sets the CHAP secrets.
fc [port_num]
Sets the Fibre Channel port parameters.
features
Sets licensed router features such as SmartWrite or additional host ports.
iscsi [port_num]
Sets the iSCSI port parameters.
isns [port_num]
Sets the iSNS parameters.
mgmt
Sets the management port parameters.
ntp
Sets the network time protocol (NTP) parameters.
properties
Sets CLI properties.
snmp
Sets the simple network management protocol (SNMP) parameters.