user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
B – Simple Network Management Protocol (SNMP)
Management Information Base (MIB)
SN0054659-00 A B-3
A
Management Information Base (MIB)
The following sections describe the QLogic management information base (MIB).
The MIB consists of four object groups:
System Information
Network Port Table
Fibre Channel Port Table
Fibre Channel Port Table
System Information
The system information objects provide the system serial number, version
numbers (hardware/software/agent), and number of ports (FC/GE).
qsrSerialNumber
qsrHwVersion
qsrSwVersion
qsrNoOfFcPorts
Syntax SnmpAdminString
Access Read only
Description The system serial number.
Syntax SnmpAdminString
Access Read only
Description The system hardware version number.
Syntax SnmpAdminString
Access Read only
Description The system software (firmware) version
number.
Syntax Unsigned32
Access Read only
Description The number of Fibre Channel ports on the
system.