user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
A – Log Messages
Fatal Log Messages
A-30 SN0054659-00 A
S
TOE Driver
The TOE driver generates the fatal log messages listed in Tab le A -1 5 and
described following the table.
292 FC processor paused due to RAM parity error.
316 FC processor system error.
346 Response queue entry contains an invalid handle.
347 FCIP: Response queue entry contains an invalid buffer type.
348 FCIP: Response queue entry contains an invalid entry type.
349 FCIP: Response queue entry contains an invalid handle.
352 FC processor external SRAM parity error count exceeded limit: FC port
disabled.
355 FC processor heartbeat failed.
400 FC processor being restarted.
Table A-15. TOE—Fatal Log Messages
ID Log Message No.
200721 QL3022:ql3xxx_probe: Adapter eth#%d, Invalid NVRAM
parameters
17
200725 QL3022:eth%x: Resetting chip. PortFatalErrStatus register =
0x%x
21
17 Encountered invalid parameters in TOE NVRAM.
21 TOE chip reset due to detection of fatal error.