user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
A – Log Messages
Fatal Log Messages
SN0054659-00 A A-29
A
10692 #%d: QLFcipInterruptServiceRoutine: Invalid interrupt status: %x 292
102716 #%d: QLIsrEventHandler: System error event (%x), MB1=%x,
MB2=%x, MB3=%x, MB4=%x, MB5=%x, MB6=%x, MB7=%x
316
102746 #%d: QLProcessResponseQueue: Invalid handle %x, type %x 346
102747 #%d: QLProcessResponseQueueFS: Invalid buffer type: %x 347
102748 #%d: QLProcessResponseQueueFS: Invalid EntryType (0x%x) 348
102749 #%d: QLProcessResponseQueueFS: Invalid handle 0x%x, type
0x%x
349
102752 #%d: QLTimer: Ext Ram parity error exceed limit cnt 0x%x, limit
0x%x, Disabled adapter
352
102755 #%d: QLTimer: Heartbeat failed 355
102800 #%d: QLRestartRisc: restart RISC 400
19 FC1 processor SRAM test failed.
20 FC1 processor power-on self-test (POST) failed.
21 FC2 processor SRAM test failed.
22 FC2 processor POST failed.
23 FC processor failed to return diagnostic results.
256 FC processor failed reset.
257 FC processor firmware load failed.
258 FC processor receive sequencer code load failed.
259 FC processor transmit sequencer code load failed.
262 FC processor firmware checksum failed.
280 FC processor firmware initialization failed.
288 FC processor paused due to internal parity error.
289 FC processor returned an invalid interrupt status.
291 FC processor invalid interrupt status.
Table A-14. Fibre Channel Driver—Fatal Log Messages (Continued)
ID Log Message No.