user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
A – Log Messages
Fatal Log Messages
SN0054659-00 A A-25
A
System
The system modules generate the error log messages listed in Table A-12 and
described following the table.
Fatal Log Messages
The following sections list and describe the fatal log messages by reporting
module:
“iSCSI Driver” on page A-25
“FC Driver” on page A-28
“TOE Driver” on page A-30
“System” on page A-31
iSCSI Driver
The following fatal log messages are common to both iSCSI ports, 1 (GE1) and 2
(GE2). They are listed in Table A- 13 and described following the table. Log
messages beginning with #0 denote iSCSI port 1 (GE1). Log messages beginning
with #1 denote iSCSI port 2 (GE2).
Table A-12. System—Error Log Messages
ID Log Message No.
237572 "Failed to kill sys killer %d\n" 4
237573 "Temperature over high threshold %d\n" 5
4 Failed to kill system task.
5 Reporting router exceeds maximum operating temperature.
Table A-13. iSCSI Driver—Fatal Log Messages
ID Log Message No.
69652 #%d: qlutm_init: Diagnostic failed, invalid SRAM 20
69653 #%d: qlutm_init: Diagnostic failed, fail reboot 21
69654 #%d: qlutm_init: Diagnostic failed, invalid NVRAM 22
69655 #%d: qlutm_init: Diagnostic failed, invalid DRAM 23
69656 #%d: qlutm_init: Failed to return diagnostic result to Bridge 24