user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
A – Log Messages
Error Log Messages
SN0054659-00 A A-11
A
41257 QLIS_LoginPduContinue: Invalid initiator name. Initiator: 297
41265 QLIS_LoginPduContinue: Target not configured for Portal 305
41267 QLIS_LoginPduContinue: Target not found. Target name: 307
41268 QLIS_LoginPduContinue: Missing target name 308
41270 QLIS_LoginPduContinue: TSIH is 0 but InitiatorName key/value
not provided
310
41272 QLIS_LoginPduContinue: CONN_STATE_IN_LOGIN, Unknown
InitTaskTag
312
41283 QLIS_LoginPduContinue: TSIH 0x%x out of range 323
41284 QLIS_LoginPduContinue: Session does not exist, invalid TSIH
0x%x
324
41353 QLIS_LoginPduContinue CHAP Validation Failure 393
41354 QLIS_LoginPduContinue Unexpected CHAP key detected 394
41508 QLBI_SetPortInfo: QLUT_AllocatePortalObject failed (PortType
0x%x, PortId 0x%x)
548
41626 QLBI_GetLunInfo: INQUIRY failed, TPB status 0x%x 666
41629 QLBI_GetLunInfo: QLBI_PassthruCommand failed for INQUIRY
(page code 0x83)
669
41635 QLBI_GetLunInfo: QLBI_PassthruCommand failed for READ
CAPACITY
675
41636 QLBI_GetLunInfo: READ CAPACITY failed, TPB status 0x%x 676
41696 QLBI_PassthruCommandCompletion: Passthru command
aborted
736
41700 QLBI_Passthru: Invalid CDB length %d bytes 740
41701 QLBI_Passthru: Invalid data length %d bytes 741
41717 QLBI_PassthruCommand: command interrupted or timed out 757
41750 QLBI_Ioctl: ERROR: Operation (0x%x) not supported in this mode 790
41768 QLBI_GetLunList: REPORT LUNS command failed 808
41769 QLBI_GetLunList: REPORT LUNS command failed with CHECK
CONDITION, SCSI STATUS 0x%02X
809
Table A-8. Application Module—Error Log Messages (Continued)
ID Log Message No.