user manual
Table Of Contents
- Table of Contents
- 1 Introduction
- 2 Command Usage
- 3 Configuring CHAP
- 4 Command Reference
- Command Listing
- Command Syntax
- Admin
- Beacon
- Clear
- Date
- FcipRoute
- FRU
- Help
- History
- Image
- Initiator
- Localmap
- Logout
- Password
- Ping
- Quit
- Reboot
- Remote Map
- Remote Peer
- Reset Factory
- Save
- Set
- Set CHAP
- Set FC
- Set Features
- Set iSCSI
- Set iSNS
- Set Mgmt
- Set NTP
- Set Properties
- Set SNMP
- Set System
- Show
- Show CHAP
- Show FC
- Show FcipRoutes
- Show Features
- Show Initiators
- Show iSCSI
- Show iSNS
- Show Localmaps
- Show Logs
- Show Memory
- Show Mgmt
- Show NTP
- Show Performance
- Show Presented Initiators
- Show Presented Targets
- Show Properties
- Show Remotemaps
- Show Remotepeers
- Show SNMP
- Show Stats
- Show System
- Show Targets
- Show VLAN
- Shutdown
- Target
- Traceroute
- A Log Messages
- B Simple Network Management Protocol (SNMP)
- Index
A – Log Messages
Informational Log Messages
A-4 SN0054659-00 A
S
iSCSI Driver
The following informational log messages are common to both iSCSI ports: 1
(GE1) and 2 (GE2). The messages are listed in Table A-2 and described following
the table. Log messages beginning with #0 denote iSCSI port 1 (GE1) and log
messages beginning with #1 denote iSCSI port 2 (GE2).
1700 iSCSI connection closed.
1715 Remote system connection established using DDB d:d.
1738 Re-enabling compression.
2051 TRB freed, State xx, Abort Reason d, Flags xx.
Table A-2. iSCSI Driver—Informational Log Messages
ID Log Message No.
86343 #%d: QLPortUp: Set link configuration 0x%x 327
86347 #%d: QLDisable: Restart RISC 331
86349 #%d: QLEnable: Restart RISC to update EEPROM 333
86352 #%d: QLPortDown: Set link configuration 0x%x 336
86874 #%d: QLIsrDecodeMailbox: Link up 858
327 iSCSI port enabled, port up.
331 Restart iSCSI processor (RISC).
333 EEPROM updated, restart iSCSI processor (RISC).
336 iSCSI port disabled, port down.
858 Link up reported by iSCSI processor for GE1 or GE 2.