Owner's Manual

ONE YEAR LIMITED WARRANTY
Q-Logic warrants to the original retail purchaser, this product to be free from defective workmanship and material when used under normal
conditions in accordance with the product's printed instructions for a period of one (1) year from date of purchase. Q-Logic agrees to remedy any
such defect or to furnish a new part in exchange for the defective one at no charge for parts or labor. This warranty is limited to Q-Logic products
and specifically excludes consequential damage to other associated equipment which may result for any reason from use with this product. In
no event shall Q-Logic be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set
forth above. Some states do not allow limitations on how long an implied warranty lasts, and/or the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific rights and you may also
have other rights which vary from state to state.
1.Save your sales receipt for warranty registration and service.
2.Contact the dealer from whom you bought Q-Logic. They will give you instructions for warranty service.
3.If no dealer is available, call Q-logic for further Instructions: (800) 680 - 2375.
You must receive an RA# before returning any defective parts.
This warranty does not cover the following:
• Damages caused by water, neglect, abuse, misuse.
• Improper installation or operation. • Damages caused by acts of God or nature.
• Damages occurring during shipment of the product to Q-Logic for repairs.
• Any product which is modified without consent of Q-Logic.
If you need warranty service, take the following steps:
For other cool Q-Logic products,
visit our website!
http://qlogic.ws
Installation of your new Q-Forms kick panels is complete.
Start enjoying your front row - center stage seats!
Continued from other side:
INSTALL GRILLS:
Cut the supplied rubber U-channel in half(approximately 20” each). Apply
rubber U-channel around the edge of the grill, trim excess U-channel if
needed and press grill into the grill opening in the Q-Forms panel.
PASSENGER’S Side:
Lay the Q-Forms kick panel into place in the approximate location and
connect the speaker wiring. Install the kick panel into the permanent
position previously held by the original kick panel. Be sure that the front
edge of the panel fits tightly against the rubber door seal. Also make sure
that the hole toward the back of the Q-Forms panel slides over the metal
stud just like the factory panel did. Install the factory plastic nut over the
metal stud and tighten. Re-install the factory threshold panel along the
bottom of the door opening. Slide the threshold panel tightly against the
bottom edge of the Q-forms panel and snap back into place. Lay the
supplied polyfill in and around the opening for the midrange driver. Install
the midrange driver as per manufacturer’s instructions. Be sure to center
driver in opening to allow clearance for the speaker grill.
After
Before