Owner's Manual

QL-K8001

1986-1995 Nissan Pickup/Pathfinder

Remove Original Kick Panel

• Remove threshold plate by removing attachment screws.

• Pull kick panel away from bulkhead to release mounting clips.

• Tilt bottom front edge upward and pull kick panel out of vehicle.

NOTE: Always check the fit of the Q-Forms into the vehicle before any cutting or modifications are done.

Install Speakers

• Cut the speaker holes into the Q-Forms before installing them into the vehicle.

• Install the speakers into the Q-Forms after they have been installed into the vehicle.

• Install speaker wiring and crossover network as per manufacturer’s instructions.

• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface.

A die grinder or keyhole saw may also be used.

• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.

• Cut speaker mounting holes taking care as saw exits rear of panel.

• Secure speakers into locations by driving screws through speaker bezel and into

mounting surface. Be careful to center speakers in mounting surface to allow

clearance for grill shell.

• Install tweeters as per manufacturer’s instructions.

Install New Q-Forms Kick Panels (Always predrill all mounting screw locations)

• Lay Q-forms kick panel in approximate location and connect speaker wiring.

• Install panel into permanent position previously held by original kickpanel. Be sure

front edge of panel fits tightly against rubber door seal.

• Reinstall threshold plate using original screws. It may be helpful

to hold panel tightly against rubber door seal while tightening

front screw.

• Install supplied mounting screws in holes at upper front edge.

• Install grill shells by pressing snugly into woofer cavity.

QL-K8001 Included Hardware:

(2) 1" Screws

(2) 6" x 8" polyfill pieces

(2) 6.25" Q-grills

Estimated Installation Time: 1.5 Hrs.

inst ver 56.1

PAGE 1
QL-K8001 1986-1995 Nissan Pickup/Pathfinder Remove Original Kick Panel • Remove threshold plate by removing attachment screws. • Pull kick panel away from bulkhead to release mounting clips. • Tilt bottom front edge upward and pull kick panel out of vehicle. NOTE: Always check the fit of the Q-Forms into the vehicle before any cutting or modifications are done. Install Speakers • • • • • • • • Cut the speaker holes into the Q-Forms before installing them into the vehicle.
PAGE 2
Q-Forms " C - series " Kickpanels for 6.5" Woofers Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done! 6.5" Woofer Mounting Instructions Please use the model specific instructions provided for the removal of the factory panels and the Q-Forms mounting instructions. These instructions provide information on properly locating the woofer in the Q-Forms kickpanel.
PAGE 3
Continued from other side: Mark Center location using ruler: This will position any area of the grill that hangs over to the back bottom edge of the woofer surface where it will not be visible when installed. With the grill on the mounting surface, mark the screw locations for the woofer. Remove the grill and align the screw locations with the the mounting template to mark to cutout location. Use a ruler and pencil to mark the center point of the cutout by lining up the mounting holes opposite one another.