Owner's Manual

ManualsBrandsQ-Logic ManualsAudio accessories & installationQ-Forms Kick Panel Enclosures

QL-K3014

Jeep Wrangler 1997 - 2006

Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done!

Continued on other side:

SPEAKER INSTALLATION:

Cut the speaker holes in the Q-Forms before installing the panels in the vehicle.

Using a hole saw of the correct size, position the pilot drill on the dimple at the

center of the speaker-mounting surface. Be careful as the hole saw exits the rear of

the panel. Install speaker wiring and crossover network as per manufacturer’s

instructions. Install tweeters and midrange drivers as per manufacturer’s instruc-

tions. The supplied foam tape may be used to ensure a good seal between the

kickpanel and the speaker.

KICKPANEL INSTALLATION:

Driver’s Side:

Place the Q-Forms kick panel in the approximate location as shown. The kick

panel will cover the existing plastic panel. Position the woofer area of the kickpanel

firmly against the firewall, sidewall and floor. Be sure to push firmly and recheck

the fit before marking and drilling the holes. Secure the kickpanel using two of the

supplied sheet metal screws.

Note: Hardtop models may have an existing wire harness which runs from the

firewall area up to the hardtop. Material may be removed from the top edge of the

kickpanel to clear the wiring harness. Please refer to the marked lines on the

backside of the kickpanel.

Passenger Side:

Place the Q-Forms kick panel in the approximate location as shown. Position the

woofer area of the kick panel firmly against the firewall, sidewall and floor. Be sure

to push firmly and recheck the fit before marking and drilling the holes. Secure the

kickpanel using two of the supplied sheet metal screws.

Supplied Hardware:

4 - #8 x 3/4" Black SMS

2 - Polyfill Sheets

1 - Foam Tape Roll

Driver Side Before

Driver Side After

Summary of content (4 pages)

PAGE 1
QL-K3014 Jeep Wrangler 1997 - 2006 Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done! SPEAKER INSTALLATION: Cut the speaker holes in the Q-Forms before installing the panels in the vehicle. Using a hole saw of the correct size, position the pilot drill on the dimple at the center of the speaker-mounting surface. Be careful as the hole saw exits the rear of the panel. Install speaker wiring and crossover network as per manufacturer’s instructions.
PAGE 2
Continued from other side: Passenger Side Driver Side Installation of your new Q-Forms kick panels is complete. Start enjoying your front row - center stage seats! ONE YEAR LIMITED WARRANTY Q-Logic warrants to the original retail purchaser, this product to be free from defective workmanship and material when used under normal conditions in accordance with the product's printed instructions for a period of one (1) year from date of purchase.
PAGE 3
Q-Forms " C - series " Kickpanels for 6.5" Woofers Note: Always check the fit of the Q-Forms panel in the vehicle BEFORE any cutting or modifications are done! 6.5" Woofer Mounting Instructions Please use the model specific instructions provided for the removal of the factory panels and the Q-Forms mounting instructions. These instructions provide information on properly locating the woofer in the Q-Forms kickpanel.
PAGE 4
Continued from other side: Mark Center location using ruler: This will position any area of the grill that hangs over to the back bottom edge of the woofer surface where it will not be visible when installed. With the grill on the mounting surface, mark the screw locations for the woofer. Remove the grill and align the screw locations with the the mounting template to mark to cutout location. Use a ruler and pencil to mark the center point of the cutout by lining up the mounting holes opposite one another.