Owner's Manual

ONE YEAR LIMITED WARRANTY
Q-Logic warrants to the original retail purchaser, this product to be free from defective workmanship and material when used under normal
conditions in accordance with the product's printed instructions for a period of one (1) year from date of purchase. Q-Logic agrees to remedy any
such defect or to furnish a new part in exchange for the defective one at no charge for parts or labor. This warranty is limited to Q-Logic products
and specifically excludes consequential damage to other associated equipment which may result for any reason from use with this product. In
no event shall Q-Logic be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set
forth above. Some states do not allow limitations on how long an implied warranty lasts, and/or the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific rights and you may also
have other rights which vary from state to state.
1.Save your sales receipt for warranty registration and service.
2.Contact the dealer from whom you bought Q-Logic. They will give you instructions for warranty service.
3.If no dealer is available, call Q-logic for further Instructions: (866) 680 - 2375.
You must receive an RA# before returning any defective parts.
This warranty does not cover the following:
• Damages caused by water, neglect, abuse, misuse.
• Improper installation or operation. • Damages caused by acts of God or nature.
• Damages occurring during shipment of the product to Q-Logic for repairs.
• Any product which is modified without consent of Q-Logic.
If you need warranty service, take the following steps:
For other cool Q-Logic products,
visit our website!
http://qlogicenclosures.com
Installation of your new Q-Forms kick panels is complete.
Start enjoying your front row - center stage seats!
Continued from other side:
Lay the Q-Forms kickpanel in the approximate location and connect the speaker
wiring. Install the Q-Forms kickpanel into the permanent postion previously held
by the factory kickpanel. Be sure that the front edge of the kickpanel fits and
tightly and evenly against the rubber door seal. Reinstall the factory sill plate
making sure that the front clip snaps into the Q-Forms kickpanel.
While pushing in and down on the kickpanel, attach the kickpanel using the
supplied 1 1/2" sheet metal screw through the predrilled hole located in the
kickpanel, through the 7/8" nylon spacer and into the sheet metal of the vehicle.
(Note: Using a 7/64" or smaller drill bit to pre-drill the screw location may aid in installation.)
NOTE: The installation of the screw and spacer may be made easier if a small
peice of tape or thin cardboard is placed over the screw once the spacer has been
placed over the screw.
Lay the polyfill in the opening for the midrange driver and install the driver as per
manufacturer's instruction.
Passenger Side Before
Passenger Side After
Passenger's Side: