Owner's Manual

ONE YEAR LIMITED WARRANTY
Q-Logic warrants to the original retail purchaser, this product to be free from defective workmanship and material when used under normal
conditions in accordance with the product's printed instructions for a period of one (1) year from date of purchase. Q-Logic agrees to remedy any
such defect or to furnish a new part in exchange for the defective one at no charge for parts or labor. This warranty is limited to Q-Logic products
and specifically excludes consequential damage to other associated equipment which may result for any reason from use with this product. In
no event shall Q-Logic be liable for incidental or consequential damages or have any liability with respect to defects other than the obligations set
forth above. Some states do not allow limitations on how long an implied warranty lasts, and/or the exclusion or limitation of incidental or
consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific rights and you may also
have other rights which vary from state to state.
1.Save your sales receipt for warranty registration and service.
2.Contact the dealer from whom you bought Q-Logic. They will give you instructions for warranty service.
3.If no dealer is available, call Q-logic for further Instructions: (866) 680 - 2375.
You must receive an RA# before returning any defective parts.
This warranty does not cover the following:
• Damages caused by water, neglect, abuse, misuse.
• Improper installation or operation. • Damages caused by acts of God or nature.
• Damages occurring during shipment of the product to Q-Logic for repairs.
• Any product which is modified without consent of Q-Logic.
If you need warranty service, take the following steps:
For other cool Q-Logic products,
visit our website!
http://qlogic.ws
Installation of your new Q-Forms kick panels is complete.
Start enjoying your front row - center stage seats!
Continued from other side:
Q-FORMS KICKPANEL INSTALLATION:
Passenger side installation:
Place the Q-Form kickpanel against the sidewall and locate the upper tab into
the factory cutout in the sheet metal. Push the panel down while rotating
towards the firewall. Hold the panel in place with one hand and check the fit
by replacing the threshold panel and tree lock. The threshold panel should
rest in the recess of the Q-Forms kickpanel. Remove the tree lock and
threshold panel. Check the area behind the mounting tabs for any wiring
harnesses, then secure the panel using three(3) of the supplied #8 x 1/2"
sheet metal screws through the pre-drilled hole in each tab and into the sheet
metal. Replacing the threshold panel and tree lock. Lay the supplied polyfill
in and around the opening for the midrange driver, and install the midrange
driver as per manufacturer’s instructions. Be sure to center driver in opening
to allow clearance for the speaker grill. Cut the supplied "U" channel into two
equal pieces. Install the rubber "U" channel over and around the edge of the
supplied grill. Press the grill into the grill opening. Reinstall the under dash
cover removed previously. Secure using the tree lock tabs and 7mm screws.
After:
Before: