Owner's Manual

QL-K1004

S-10 / Sonoma 1994-1997

S-10 Blazer / S-15 Jimmy 1995-1997

Remove Original Kick Panel

• Remove threshold plate by pulling up to detach clips.

• Pull kick panel away from bulkhead to release mounting clips.

• Tilt bottom front edge upward, slide panel rearward to clear hood latch handle, and pull kick

panel out of vehicle.

Modify Parking Brake Pedal

• Using two crescent wrenches, carefully bend brake pedal arm so that pedal pad is relocated

approximately 1.5 inches to the right.

Passenger Side: Relocate Computer Module

• Remove mounting screws securing module to kickpanel.

• Remount in new position below the glovebox.

NOTE: Always check the fit of the Q-forms into the vehicle before any cutting or modifications are done.

Install Speakers␣

• Cut the speaker holes into the Q-Forms before installing them into the vehicle.

• Install the speakers into the Q-Forms after they have been installed into the vehicle.

• Install speaker wiring and crossover network as per manufacturer’s instructions.

• Using a hole saw of correct size, position pilot drill on dimple at center of speaker

mounting surface. A die grinder or keyhole saw may also be used.

• Lay the supplied polyfill in and around the Q-forms cavity behind the speakers.

• Cut speaker mounting holes taking care as saw exits rear of panel.

• Secure speakers into locations by driving screws through speaker bezel and into

mounting surface. Be careful to center speakers in mounting surface to allow

clearance for grill shell.

• Install tweeters as per manufacturer’s instructions.

Install New Q-Forms Kick Panels (Always predrill all mounting screw locations)

• Lay Q-forms kick panel in approximate location and connect speaker wiring.

• Install panel into permanent position previously held by original kick panel.

Be sure front edge of panel fits tightly against rubber door seal.

• Reinstall threshold plate. It may be helpful to hold panel tightly against

rubber door seal while aligning the plastic nipple with the hole.

• Install screw and spacer through hole at upper rear edge of panel and

drive into inner bulkhead sheet metal.

• Install grill shells by pressing snugly into woofer cavity.

QL-K1004 Included Hardware:

(2) 1" plastic spacers

(2) 1.5" screws

(2) 6" x 8" polyfil peices

(2) 6.25" Q-grills Estimated Installation Time: 2.0 Hrs.

inst ver 26.2

PAGE 1
QL-K1004 S-10 / Sonoma 1994-1997 S-10 Blazer / S-15 Jimmy 1995-1997 Remove Original Kick Panel • Remove threshold plate by pulling up to detach clips. • Pull kick panel away from bulkhead to release mounting clips. • Tilt bottom front edge upward, slide panel rearward to clear hood latch handle, and pull kick panel out of vehicle. Modify Parking Brake Pedal • Using two crescent wrenches, carefully bend brake pedal arm so that pedal pad is relocated approximately 1.5 inches to the right.