Owner's Manual

QL-K1003
GM S-10 / S-15 1982-1993
GM S-10 Blazer / S-15 Jimmy 1982-1994
Remove Original Kick Panel
• Remove threshold plate by removing attachment screws.
• Pull kick-panel away from bulkhead to release mounting clips.
• Tilt bottom front edge upward and pull kick panel out of vehicle.
NOTE: Always check the fit of the Q-forms into the vehicle before any cutting or modifications are done.
Install Speakers␣
• Cut the speaker holes into the Q-Forms before installing them into the vehicle.
• Install the speakers into the Q-Forms after they have been installed into the vehicle.
• Install speaker wiring and crossover network as per manufacturer’s instructions.
• Using a hole saw of correct size, position pilot drill on dimple at center of speaker mounting surface. A die
grinder or keyhole saw may also be used.
• Lay the supplied polyfill in and around the Q-forms cavity behind the
speakers.
• Cut speaker mounting holes taking care as saw exits rear of panel.
• Secure speakers into locations by driving screws through speaker bezel
and into mounting surface. Be careful to center speakers in mounting
surface to allow clearance for grill shell.
• Install tweeters as per manufacturer’s instructions.
Install New Q-Forms Kick Panels
(Always predrill all mounting screw locations)
• Lay Q-forms kick panel in approximate location and connect speaker wiring.
• Install panel into permanent position previously held by original kick-panel.
Be sure front edge of panel fits tightly against rubber door seal.
• If particularly deep speakers are to be installed, it may be necessary to cut
into bulkhead sheet metal for additional clearance.
• Reinstall threshold plate using original screws. It may be helpful to hold
panel tightly against rubber door seal while tightening front screw.
• Install (2) 1" sheet metal screws through holes at top of
panel and drive into inner bulkhead sheetmetal. It may be helpful to predrill
screw pilot hole if installed without power tools.
• Install grill shells by pressing snugly into woofer cavity.
QL-K1003 Included Hardware:
6 - 1" screws
2 - 6" x 8" polyfill pieces
2 - 6.25" Q-grills
Estimated Installation Time: 1.5 Hrs.
inst ver 25.2