Owner's Manual

QL-C1MST112

Ford Mustang Coupe 2005-up

Thanks for choosing Q-Logic! - Quite possibly the most advanced loudspeaker enclosure available

for Mobile Electronics. Follow the instructions to custom fit your driver to the enclosure.

YOUR INSTALLATION CAN MAKE A HUGE DIFFERENCE IN THE SOUND QUALITY!

INSTALLATION INSTRUCTIONS:

Enclosure Installation

Continued on other side:

Begin the installation process by removing the 4 pin-lock and 2

tree-lock fasteners in the trunk rear valance piece, and remove the

valance. Next, remove the tree locks from the passenger side fender well

carpeting(see picture). Pull the carpet panel back exposing the sheet

metal with several holes punched in it. Install the supplied body clip in

the lower larger square hole in the sheet metal directly behind the wheel

well(see picture). Thread the supplied 1\4-20 x 1" bolt into the clip. The

bracket which held the upper treelock may be bent toward the center of

the car approximately 1/4". This is not required but will aid in the installa-

tion of the upper enclosure bolt later. Replace the carpeting, locate the

bolt head and make a 3-sided box cut around the bolt and fold the cut

panel under the trunk liner(see picture). Remove the bolt for installation.

Tuck the carpet behind the upper bracket and push back into the corner.

When the enclosure is installed the carpet will not extend under the rear

valance. Fold the trunk floor carpeting over, exposing the wire loom and

studs in the floor channel. Remove the wiring harness from the 2 rear-

most studs and move the harness towards the center of the trunk. Slide

the enclosure into the rear corner until the brackets are located on the

two rear studs. Install the supplied 1/4-20 x 1" bolt through the predrilled

hole in the back of the enclosure and into the body clip. Install the

supplied 8mm socket head bolt and washer through the carpeted baffle

and into the upper factory bracket. Install the two supplied nuts on the

studs securing the brackets and tighten all nuts and bolts. Replace the

wiring harness to the original factory location.

QL-C1MST112 After

Remove Tree Locks

Install Body Clip

PAGE 1
QL-C1MST112 Ford Mustang Coupe 2005-up Thanks for choosing Q-Logic! - Quite possibly the most advanced loudspeaker enclosure available for Mobile Electronics. Follow the instructions to custom fit your driver to the enclosure. YOUR INSTALLATION CAN MAKE A HUGE DIFFERENCE IN THE SOUND QUALITY! INSTALLATION INSTRUCTIONS: Enclosure Installation Begin the installation process by removing the 4 pin-lock and 2 tree-lock fasteners in the trunk rear valance piece, and remove the valance.
PAGE 2
Continued from other side: Cut Factory Carpet Woofer Installation: Attach the speaker lead from the amplifier to the terminal cup on the enclosure before installing the faceplate. Before installing the woofer and faceplate in the vehicle place the Qx Ring and the woofer into the faceplate and align the dustcap as desired. Predrill the woofer screw locations with an 1/8" drill bit. Place the supplied polyfill inside the enclosure. Place the faceplate and Qx Ring in place on the front of the enclosure.