User's Manual

1–Product Overview
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
SN0054671-00 A 1-7
QLflash Command Line Options
The executable file QLflash.exe is used by the UPDATE.BAT file to update your
adapter multiboot-code. The application QLflash.exe may be used to read,
write, or verify either the multi-boot image or the NVRAM on the adapter.
The following paragraphs describe the command line options available with this
utility. Use of QLflash will modify the way your adapter operates, and it must be
used with extreme caution.
Certain features (that is, the NVRAM options) may require additional data.
Files and passwords are not provided in this file.
QLflash Options
QLflash.exe <1...N | ALL> [options]
/SLT
SLT: Sets the application to silent mode
Use application return code for success or failure
/SIL=filename.ext
SIL: Load multiflash image from file
/PRV | /VPP | /PRN
PRV: Print firmware versions
VPP: Print VPD contents
PRN: Print MAC addresses and WWPN
/CFU=filename.ext | /CFS=filename.ext | /CFC=filename.ext
CFU: Flash board configuration from file
CFS: Save board configuration file (need template file BRDCFG.DAT)
CFC: Compare board configuration to a binary file
/NVU=filename.ext | /NVS=filename.ext | /NVC=filename.ext
NVU: Flash NVRAM from file
NVS: Save NVRAM to file (need template file NVRAM.DAT)
NVC: Compare Flash to NVRAM file
/UIL=filename.ext | /UIS=filename.ext | /UIC=filename.ext
UIL: Flash user info data from file
UIS: Save user info data to file
UIC: Compare user info data to a binary file