User's Manual

SN0054667-00 C xxi
Preface
This guide describes QConvergeConsole
®
CLI, which is used to configure and
manage QLogic Fibre Channel adapters, Intelligent Ethernet adapters, and
Converged Network Adapters within SANs.
What’s in this Guide
This guide contains the basic information you need to get started with
QConvergeConsole CLI.
This preface explains the QConvergeConsole CLI help system, describes the
typographic conventions used in this guide, lists related documents, specifies the
intended audience, refers you to the QLogic license agreements, and provides
technical support and contact information.
The remainder of the user's guide is organized into the following chapters:
 Chapter 1 System Requirements lists the hardware, software requirements,
and operating system requirements needed for the successful operation of
the QConvergeConsole CLI.
 Chapter 2 Installing and Uninstalling QConvergeConsole CLI describes how
to install and uninstall the utility.
 Chapter 3 Getting Started describes how to start QConvergeConsole CLI on
Windows and Linux platforms. This chapter also describes how to view
detailed information about command parameters and options.
 Chapter 4 NIC Noninteractive Commands describes the noninteractive NIC
command syntax and parameters.
 Chapter 5 Fibre Channel Noninteractive Commands describes the
noninteractive Fibre Channel command syntax and parameters.
 Chapter 6 iSCSI Noninteractive Commands describes the noninteractive
iSCSI command syntax and parameters.
 Chapter 7 NIC Partitioning (NPAR) Noninteractive Commands describes the
noninteractive NIC Partitioning (NPAR) command syntax and parameters.
 Chapter 8 NIC Interactive Commands contains a description of the
QConvergeConsole CLI NIC interactive mode menus.
 Chapter 9 Fibre Channel Interactive Commands contains a description of
the QConvergeConsole CLI Fibre Channel interactive mode menus.