User's Manual

B – Command Line Interface
Show Command
B-58 59042-06 A
0
FBusy Number of times the switch sent a F_BSY because Class 2
frame could not be delivered within ED_TOV time. Number
of class 2 and class 3 fabric busy (F_BSY) frames
generated by this port in response to incoming frames.
This usually indicates a busy condition on the fabric or
N_Port that is preventing delivery of this frame.
Flowerrors Received a frame when there were no available credits.
FReject Number of frames from devices that were rejected.
InvalidCRC Invalid CRC detected.
InvalidDestAddr Invalid destination address detected.
LIP_AL_PD_ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific)
resets, performed.
LIP_F7_AL_PS This LIP is used to reinitialize the loop. An L_Port,
identified by AL_PS, may have noticed a performance
degradation and is trying to restore the loop.
LIP_F8_AL_PS This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
LIP_F7_F7 A loop initialization primitive frame used to acquire a valid
AL_PA.
LIP_F8_F7 A loop initialization primitive frame used to indicate that a
loop failure has been detected at the receiver.
Link Failures Number of optical link failures detected by this port. A link
failure is a loss of synchronization or a loss of signal while
not in the offline state. A loss of signal causes the switch to
attempt to re-establish the link. If the link is not
re-established, a link failure is counted. A link reset is
performed after a link failure.
Login Number of device logins
Logout Number of device logouts
LoopTimeouts A two (2) second timeout as specified by FC-AL-2.
LossOfSync Number of synchronization losses (>100 ms) detected by
this port. A loss of synchronization is detected by receipt of
an invalid transmission word.
PrimSeqErrors Primitive sequence errors detected.
Table B-15. Show Port Parameters (Continued)
Entry Description