User's Manual

B – Command Line Interface
Set Config Command
B-36 59042-06 A
0
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets. Table B-10 describes the Set Config Switch
parameters.
Table B-10. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online,
offline, or diagnostics. The default is
Online.
BroadcastEnabled Broadcast. Enables (True) or disables
(False) forwarding of broadcast frames.
The default is True.
InbandEnabled Inband management. Enables (True) or
disables (False) the ability to manage
the switch over an ISL. The default is
True.
FDMIEnabled Fabric Device Monitoring Interface.
Enables (True) or disables (False) the
monitoring of target and initiator device
information.
FDMIEntries The number of device entries to
maintain in the FDMI database. Enter a
number from 0–1000. The default is
1000.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False)
dynamic reassignment of the
domain ID. The default is False.
SymbolicName Descriptive name for the switch. The
name can be up to 32 characters
excluding #, semicolon (;), and comma
(,). The default is SANbox2.
R_A_TOV Resource Allocation Timeout Value.
The number of milliseconds the switch
waits to allow two ports to allocate
enough resources to establish a link.
The default is 10000.