User Manual

Q-BOT Micro Quad copter Flight Control Features:
A. The receiver
At the back of the receiver it is two led’s, between the two led’s there is a little push
button. Push this so the led on the left side is red. This was the only mode the Q-BOT
would work on my TX (Spektrum DX6i)
I don’t know if this is only on my radio BUT all channels are set to reverse…
B. Bind
The Q-BOT must be bound to the transmitter before it will operate for the first time. The
detailed operation is as followed:
Do NOT turn on the transmitter at first, but power on the Q-BOT (put in battery). Wait for
LED to start blinking fast, the Q-BOT will now be in frequency mode; then turn on the
transmitter. When the Q-BOT’s LED flash slowly it means it has received signal, do not
move the Q-BOT until the LED stays on, it can fly directly after LED is lit.
It is unnecessary to bind with transmitter next flight, but turn the transmitter on first, and
then power on the Q-BOT.
C. Q-BOT power-up initialization
Q-BOT will be initialized when it connects to power. Once it connects to power, LED will
flash, and then Q-BOT will wait for transmitter signal. Make sure you have turned the
transmitter ON, and joystick is in the bottom. The LED is not lit during waiting for the
remote control signal. If no signal is received within the specified time, then reenter the
frequency mode. Receiving the transmitter signal, it will go into the gyroscope self-test
status, at this time the LED will flash slowly (about every two sec). Keep the Q-BOT on a
flat surface no vibration; do NOT hold it in your hand. When Gyro self-test is completed
and LED stays on means it can fly.
D. Low-voltage protection
When the battery voltage is lower than 3.0V, the Q-BOT will go into the low voltage
protection mode. Then LED will flash, while slowly reducing the speed of the motor until
the motor stops.