User manual

33H.264 Network DVR User Manual
SECTION 4: DVR SOFTWARE USAGE
4.6 SYSTEM INFO
Use this menu to setup several system level parameters including password and video format, and to
initiate a rmware upgrade. Move to SYSTEM INFO, then press ENTER to open this submenu. The
SYSTEM INFO screen shows the current settings.
Submenu parameters include:
• SERIAL TYPE – Serial communications methodology of the DVR (RS485).
• BAUD RATE – Set the baud rate of the DVR. Options are 2400, 9600, 19200, 38400, 57600, or
115200.
• HOST ID – Set the ID of the DVR (0 ~ 254).
• PASSWORD – Set the password for accessing the DVR system. Passwords can have up to 4 digits.
• RESET DEFAULT – Press ENTER to reset all parameters to the default values. When resetting
parameters, select YES to conrm or NO to cancel.
• CLEAR HDD – Select the HDD. Press ENTER, then select YES to conrm to clear HDD or NO to
cancel.
• UPGRADE – For upgrading rmware/OSD. See “Firmware / OSD upgrade” for more information.
• R.E.T.R. (MIN) – Remote Event Trigger Recording (selected models). Select the timeout after which
the R.E.T.R. function will be activated. Options include 03, 05, 10, or 30 seconds.
R.E.T.R. On – Press the R.E.T.R. key on the IR remote control to enable the timeout function. Enter
the password, and the R.E.T.R. delay icon (green background) appears. When the RETR function is
activated, the R.E.T.R. On icon (red background) appears.
R.E.T.R. Off – Press any key (except POWER) and enter the password to turn off R.E.T.R.