User manual
32
www.supercircuits.com
SECTION 4: DVR SOFTWARE USAGE
Submenu parameters include:
• TITLE – Show the title of each channel set in the CAMERA menu.
• DEVICE – Select the type of device (CAMERA/PTZ) on the channel.
• ID – Set the ID number (0 ~ 255) for a PTZ camera. After connecting to a PTZ camera, the default
ID of the PTZ camera will be shown on the screen.
• PROTOCOL – Select NORMAL (Supercircuits protocol), P-D (PELCO-D), or P-P (PELCO-P) protocol.
• RATE – Set the baud rate of each channel (2400/4800/9600/19200/57600/115200) to match
the setting in the camera.
4.5.9 PTZ camera setup
a. In the REMOTE submenu, highlight the channel where the speed dome camera is attached.
b. In the DEVICE column, select PTZ (for the speed dome camera).
c. Move to the ID column and set the ID number of the camera.
d. In the PROTOCOL column select P-D (for Pelco-D), P-P (for Pelco-P), or NORMAL for all
other protocols.
e. Set the baud rate to the value congured in the camera.
f. Press MENU to conrm your entries and exit the menu.