User manual

24
www.supercircuits.com
SECTION 4: DVR SOFTWARE USAGE
Table 2. Detection area setup
Transparent block indicates an area monitored for detection. Press ENTER to conrm the start area.
Use the t and/or u buttons to choose the width of the
detection area.
Use the p and/or q buttons to choose the height of the
area.
You can also set up multi-detection area. When any movement is detected, the grids are ashing.
• LS – Level of Sensitivity (on selected models). Use LS to set the sensitivity for comparing two
different images. A small value represents a high sensitivity for motion detection.