User manual

19H.264 Network DVR User Manual

SECTION 4: DVR SOFTWARE USAGE

• DETECTION TIMER – Use the p and/or q buttons to change the setting (ON/OFF). When it is

ON, press ENTER to open the submenu for setting detection sensing time.

X axis 0 ~ 24 hours. Each time interval within a square is two hours divided into four 30-minute segments.

Y axis Sunday ~ Saturday

Operation

Move to the start time point then press ENTER to set the starting time (marked in red color). Use p, q, t, or

u to move forward in time to the ending time. Press ENTER again to set the ending time (marked in yellow).

Press MENU to exit.

4.4.4 DATE

In the QUICK START menu, go to the DATE icon to set the system date and time. This setting should only

be made during initial setup of the DVR and after replacing the DVR battery.

NOTE

DO NOT change the date or time of your DVR after the recording function is activated. Since

recorded data is time stamped, old data may become unusable. If the date or time is changed

after recording is activated, clear all HDD data.