User manual

9H.264 Network DVR User Manual
SECTION 3: CONNECTIONS AND SETUP
iii. Secure the HDD to the bracket with four screws, two on each side.
iv. Connect the power and data bus cables to the HDD (see photos above).
v. Place the bracket (with the HDD) back into the DVR and secure it to the chassis.
5. Reinstall the DVR top cover.
6. Reconnect the power adapter.
3.1.2 HDD installation for DMR40DVD
For DVRs with a DVD drive, the HDD is installed in the right side bracket. For DVRs without a DVD drive,
the HDD is installed in the bracket on the left.
NOTE
The following describes an HDD installation into a 4-channel DVR WITHOUT a DVD drive. If your
DVR has a DVD drive, ignore steps 3.a and 3.d.
1. Power off the DVR and disconnect the power adapter.
2. Remove the DVR top cover.
3. Position the DVR so that you are facing the rear panel.
a. Remove the left HDD bracket from the chassis. If your DVR includes a DVD drive, skip this
step and continue with step 3b.
> > > OPENING THE DVR ENCLOSURE WILL VOID THE WARRANTY < < <