User manual

8
www.supercircuits.com
SECTION 3: CONNECTIONS AND SETUP
4. The HDD may be installed in the left or right bracket:
To install the HDD in the left bracket:
i. Orient the HDD so that the circuit board side is facing up. Connect the power and data
bus cables to the HDD.
ii. Position the HDD in the left bracket with the circuit board toward the bracket (down).
iii. Secure the HDD to the bracket with four screws, two on each side.
To install the HDD in the middle bracket:
i. Remove the middle bracket from the DVR chassis.
ii. Orient the HDD so that the circuit board side is facing up, then slide the HDD into the
bracket.
> > > OPENING THE DVR ENCLOSURE WILL VOID THE WARRANTY < < <