Manualshelf

User manual

ManualsBrandsPyxis ManualsComputer equipmentLite H.264
11121314151617181920
7H.264 Network DVR User Manual
SECTION 3: CONNECTIONS AND SETUP
SECTION 3
Connections and Setup
The hard disk drive (HDD) included in your system is a security grade device, factory tested and certied
to be functional with all operations of the DVR.
NOTE
Opening the DVR enclosure will void the warranty.
If you need to change the HDD installed in your DVR, return the device to Supercircuits for a
factory installation (preserves the warranty), or refer to the HDD compatibility list in Appendix C for
recommended HDD models. If installing an HDD, use the following instructions.
3.1 HDD installation
> > > OPENING THE DVR ENCLOSURE WILL VOID THE WARRANTY < < <
The HDD you install must be compatible with the DVR hardware. The DVR accommodates only SATA
HDDs. Refer to the HDD compatibility list in Appendix C.
CAUTION

The DVR must be powered off when installing an HDD.
3.1.1 HDD installation for DMR42DVD and DMR41DVD
To install the HDD, do the following:
1. Power off the DVR and disconnect the power adapter.
2. Remove the DVR top cover.
3. With the front panel facing you, nd the two HDD brackets. One is on the left and one in the middle.