Specifications
[ 1.350000] hub 2-0:1.0: 1 port detected
[ 1.350000] mousedev: PS/2 mouse device common for all mice
[ 1.360000] stmp3xxx-rtc 80056000.rtc: rtc core: registered 80056000.rtc as rtc0
[ 1.370000] i2c /dev entries driver
[ 1.410000] mxs-mmc 80010000.ssp: initialized
[ 1.410000] usbcore: registered new interface driver usbhid
[ 1.420000] usbhid: USB HID core driver
[ 1.440000] sgtl5000 0-000a: Failed to get supply 'VDDD': -517
[ 1.450000] 0-000a: 1200 mV normal
[ 1.450000] sgtl5000 0-000a: Using internal LDO instead of VDDD
[ 1.460000] sgtl5000 0-000a: sgtl5000 revision 0x11
[ 1.470000] mxs-sgtl5000 sound.10: sgtl5000 <-> 80042000.saif mapping ok
[ 1.480000] mxs-sgtl5000 sound.10: sgtl5000 <-> 80046000.saif mapping ok
[ 1.490000] TCP: cubic registered
[ 1.490000] Initializing XFRM netlink socket
[ 1.500000] NET: Registered protocol family 17
[ 1.500000] NET: Registered protocol family 15
[ 1.510000] can: controller area network core (rev 20120528 abi 9)
[ 1.510000] NET: Registered protocol family 29
[ 1.520000] can: raw protocol (rev 20120528)
[ 1.520000] can: broadcast manager protocol (rev 20120528 t)
[ 1.530000] Key type dns_resolver registered
[ 1.540000] stmp3xxx-rtc 80056000.rtc: setting system clock to 2012-10-02 16:55:53 UTC (1349196953)
[ 1.550000] eth0: Freescale FEC PHY driver [Micrel KSZ8021] (mii_bus:phy_addr=800f0000.etherne:00, irq=-1)
[ 1.660000] mmc0: new high speed SD card at address 0002
[ 1.670000] mmcblk0: mmc0:0002 00000 1.90 GiB
[ 1.680000] mmcblk0: p1 p2 p3
[ 3.550000] libphy: 800f0000.etherne:00 - Link is Up - 100/Full
[ 3.580000] IP-Config: Complete:
[ 3.580000] device=eth0, addr=192.168.20.33, mask=255.255.0.0, gw=192.168.1.254
[ 3.590000] host=m28, domain=, nis-domain=(none)
[ 3.590000] bootserver=192.168.1.1, rootserver=192.168.1.1, rootpath=
[ 3.600000] ALSA device list:
[ 3.600000] #0: mxs_sgtl5000
[ 3.620000] VFS: Mounted root (nfs filesystem) on device 0:12.
[ 3.630000] Freeing init memory: 168K
INIT: version 2.88 booting
Starting udev
[ 20.630000] EXT4-fs (mmcblk0): VFS: Can't find ext4 filesystem
[ 20.640000] EXT3-fs (mmcblk0): error: can't find ext3 filesystem on dev mmcblk0.
[ 20.650000] EXT2-fs (mmcblk0): error: can't find an ext2 filesystem on dev mmcblk0.
[ 20.660000] FAT-fs (mmcblk0): bogus number of reserved sectors
[ 20.660000] FAT-fs (mmcblk0): Can't find a valid FAT filesystem
[ 20.680000] FAT-fs (mmcblk0): bogus number of reserved sectors
[ 20.690000] FAT-fs (mmcblk0): Can't find a valid FAT filesystem
[ 22.250000] EXT4-fs (mmcblk0p1): VFS: Can't find ext4 filesystem
[ 22.260000] EXT3-fs (mmcblk0p1): error: can't find ext3 filesystem on dev mmcblk0p1.
[ 22.270000] EXT2-fs (mmcblk0p1): error: can't find an ext2 filesystem on dev mmcblk0p1.
[ 22.290000] FAT-fs (mmcblk0p1): bogus number of reserved sectors
[ 22.290000] FAT-fs (mmcblk0p1): Can't find a valid FAT filesystem
[ 22.330000] FAT-fs (mmcblk0p1): bogus number of reserved sectors
[ 22.330000] FAT-fs (mmcblk0p1): Can't find a valid FAT filesystem
[ 22.800000] EXT4-fs (mmcblk0p3): warning: maximal mount count reached, running e2fsck is recommended
[ 22.860000] EXT4-fs (mmcblk0p3): mounted filesystem with ordered data mode. Opts: (null)
Starting Bootlog daemon: bootlogd.
Configuring network interfaces... ifup skipped for nfsroot interface eth0
run-parts: /etc/network/if-pre-up.d/nfsroot exited with code 1
done.
Starting portmap daemon...
Unknown HZ value! (91) Assume 100.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1
Starting atd: OK
INIT: Entering runlevel: 5
Starting system message bus: dbus.
Starting OpenBSD Secure Shell server: sshd
done.
7.5.1. Bootlog of tftp'd Linux kernel with Root Filesystemover NFS 93