Specifications

Board: TQM860LDB0A3-T50.202
DRAM: 16 MB
FLASH: 8 MB
In: serial
Out: serial
Err: serial
Net: SCC ETHERNET, FEC ETHERNET [PRIME]
PCMCIA: 3.3V card found: Transcend 256M
Fixed Disk Card
IDE interface
[silicon] [unique] [single] [sleep] [standby] [idle] [low power]
Bus 0: OK
Device 0: Model: Transcend 256M Firm: 1.1 Ser#: SSSC256M04Z27A25906T
Type: Removable Hard Disk
Capacity: 244.5 MB = 0.2 GB (500736 x 512)
Type "run flash_nfs" to mount root filesystem over NFS
Hit any key to stop autoboot: 0
reading linux.img
1025657 bytes read
## Booting image at 00200000 ...
Image Name: Linux with Pivot Root Helper
Created: 2005-06-13 0:32:41 UTC
Image Type: PowerPC Linux Multi-File Image (gzip compressed)
Data Size: 1025593 Bytes = 1001.6 kB
Load Address: 00000000
Entry Point: 00000000
Contents:
Image 0: 787146 Bytes = 768.7 kB
Image 1: 238433 Bytes = 232.8 kB
Verifying Checksum ... OK
Uncompressing Multi-File Image ... OK
Loading Ramdisk to 00f3d000, end 00f77361 ... OK
Linux version 2.4.25 (wd@xpert) (gcc version 3.3.3 (DENX ELDK 3.1.1 3.3.3-9)) #1 Mon Jun 13 02:32:10 MEST 2005
On node 0 totalpages: 4096
zone(0): 4096 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: rw ip=192.168.3.80:192.168.3.1::255.255.255.0:tqm860l:eth1:off panic=1
Decrementer Frequency = 187500000/60
Calibrating delay loop... 49.86 BogoMIPS
...
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 232k freed
VFS: Mounted root (ext2 filesystem).
Red Hat nash version 4.1.18 starting
Mounting /proc filesystem
Creating block devices
Creating root device
Mounting flash card
hda: hda1
hda: hda1
losetup for filesystem image
Mounting root filesystem image
Running pivot_root
Freeing unused kernel memory: 60k init
BusyBox v0.60.5 (2005.03.07-06:54+0000) Built-in shell (msh)
Enter 'help' for a list of built-in commands.
# ### Application running ...
9.5.6. Root File System in a Read-Only File in a FAT File System 125