Installation guide

Appendix A. General Parameters and Modules 271
Hardware Module Parameters
ISP16, MAD16, or Mozart
sound card CD-ROM interface
(OPTi 82C928 and OPTi
82C929) with
Sanyo/Panasonic, Sony, or
Mitsumi drives
isp16.o isp16=io_port,IRQ,dma,
drive_type OR
isp16_cdrom_base=io_port
isp16_cdrom_irq=IRQ
isp16_cdrom_dma=dma
isp16_cdrom_type=drive_type
Mitsumi CD-ROM, Standard mcd.o mcd=io_port,IRQ
Mitsumi CD-ROM,
Experimental
mcdx.o mcdx=io_port_1,IRQ_1,
io_port_n,IRQ_n
Optics storage 8000 AT
"Dolphin" drive, Lasermate
CR328A
optcd.o
Parallel-Port IDE CD-ROM pcd.o
SB Pro 16 Compatible sbpcd.o sbpcd=io_port
Sanyo CDR-H94A sjcd.o sjcd=io_port OR
sjcd_base=io_port
Sony CDU-535 & 531 (some
Procomm drives)
sonycd535.o sonycd535=io_port
Table A-1. Hardware Parameters
Here are some examples of these modules in use:
Configuration Example
ATAPI CD-ROM, jumpered as master on the
second IDE channel
hdc=cdrom
non-IDE Mitsumi CD-ROM on port 340, IRQ
11
mcd=0x340,11
Three non-IDE Mitsumi CD-ROM drives using
the experimental driver, io ports 300, 304, and
320 with IRQs 5, 10 and 11
mcdx=0x300,5,0x304,10,0x320,11
Sony CDU 31 or 33 at port 340, no IRQ cdu31=0x340,0 OR cdu31_port=0x340
cdu31a_irq=0
Aztech CD-ROM at port 220 aztcd=0x220
Panasonic-type CD-ROM on a SoundBlaster
interface at port 230
sbpcd=0x230,1
Phillips/LMS cm206 and cm260 at IO 340 and
IRQ 11
cm206=0x340,11
Goldstar R420 at IO 300 gscd=0x300
Mitsumi drive on a MAD16 soundcard at IO
Addr 330 and IRQ 1, probing DMA
isp16=0x330,11,0,Mitsumi
Sony CDU 531 at IO address 320 sonycd535=0x320
Table A-2. Hardware Parameters Configuration Examples