Installation manual
PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 67
MAINS FAIL
xxx
Mains supply failed System detects mains frequency out of
specification, as well as voltage. Note:
'AC FAIL'
timer operative
FUSE x
FAULT
Fuse identified failed,
OR Output protected by
fuse drawing excessive
current
Fuse 1 = PGMs
Fuse 2 = BELL
Fuse 3 = AUX
Fuse 4 = BATTERY
Fuse 5 = BUS
LOW VOLTS
xxx
Power supply volts low
Battery volts below normal 'battery fault' level
during mains failure
ENGINEER INDICATIONS
Fault Description Solution
Engineer
Access
Denied
Access to Engineer menu
NOT possible, as system is
not fully disarmed.
Ensure that ALL partitions are disarmed, using a
suitable user codes / tags at appropriate keypads /
readers.
Check Failed
Input xxx
Input in fault on attempting
to exit Engineer mode.
Applies to 24-hour tamper, or other input types that
would generate an alarm condition if the system
were returned to disarmed mode.
Also applies to tamper fault on other input types.
Check for fault on input, or omit in programming.
Error input
part’ns not
accessible
A input has been
programmed to a partition
for which no arming point is
valid to disarm.
It would therefore be impossible to fully disarm the
system after a tamper alarm on that input.
Programming must be adjusted before exiting
Engineer mode.
Error some
part’ns cannot
be disarmed
Arming points have been
programmed such that it is
possible to arm a partition,
but not disarm it.
Programming must be adjusted before exiting
Engineer mode.
CHAPTER 6: CONTACT INFORMATION
Address
Pyronix Ltd.
Pyronix House
Braithwell Way
Hellaby, Rotherham
S66 8QY, UK
Help Line
Customer Support line (UK only):
0845 6434 999
(local rate) Or telephone: 01709 535225
Opening Times
Opening hours: 7:00 AM – 7:30 PM
Monday to Friday
Email:
customer.support@pyronix.com
Websites:
www.pyronix.com
www.dd243.co.uk
Pyronix Ltd. reserves the right to adjust specifications of this system, at any time and without notice, in the
interests of product improvement. Pyronix Ltd. is an independent British company specialising in the
design and manufacture of high-quality security control equipment.