Installation manual

PCX 256 PROGRAMMING MANUAL
Page: 40 RINS868-6
Type Defaults Active Restore
0059 Engineer Access
When entering Engineer
Mode
When leaving Engineer
Mode
0060 Initialise Digi At power up Live for 45 seconds
0063 Test ATE/GSM
Test signalling through PSTN
and GSM. Activates when a
test call is sent.
(used for specific GSMs)
When test completed
0064 Test ATS
ATE 10
DIGI 10
Test signalling through PSTN
and GSM. Activates when a
test call is sent.
When test completed
0065 Zone Activity F1
Activates when there is no
activity on a zone with
respect to the “NAT timers”
in Change Timers.
When there is activity.
0066 ATE Not Used Makes the ATE pin 5V.
A repeating block of output types should be noted:
0202 Hold Up A As 0002 for Partition A / Arm Level A events only
0203 Intruder A As 0003 for Partition A / Arm Level A events only
0204 Final Arm A As 0004 for Partition A / Arm Level A events only
0206 Confirmed A As 0006 for Partition A / Arm Level A events only
0207 Tamper A As 0007 for Partition A / Arm Level A events only
0208 Duress A As 0008 for Partition A / Arm Level A events only
0209 HU Device A As 0009 for Partition A / Arm Level A events only
0213 Secure Intr A As 0013 for Partition A / Arm Level A events only
0214 Bell A As 0014 for Partition A / Arm Level A events only
0216 Strobe A As 0016 for Partition A / Arm Level A events only
0217 Omit At Rearm A As 0017 for Partition A / Arm Level A events only
0218 Unconfirmed A As 0018 for Partition A / Arm Level A events only
0219 Can Arm A As 0019 for Partition A / Arm Level A events only
0220 Exit Starts A As 0020 for Partition A / Arm Level A events only
Then this pattern repeats for each other partitions so that:
0221-0240 Partition / Arm Level B 0361-0380 Partition / Arm Level 4
0241-0260 Partition / Arm Level C 0381-0400 Partition / Arm Level 5
0261-0280 Partition / Arm Level D 0401-0420 Partition / Arm Level 6
0281-0300 Partition / Arm Level 0 0421-0440 Partition / Arm Level 7
0301-0320 Partition / Arm Level 1 0441-0460 Partition / Arm Level 8
0321-0340 Partition / Arm Level 2 0461-0480 Partition / Arm Level 9
0341-0360 Partition / Arm Level 3
1xxx Follow input xxx When input is activated When input clears
i.e. add 1000 to the input number to select output required
NOTE: The following additional configurations are available, but are NOT programmable:
Partition Sounder
The outputs of the RIX2 and PROX/INT are fixed as a
loudspeaker and can be used as a partitioning sounder,
partitions are selected in the ‘Assign Keypads’ section –
see page: 24