Installation manual

PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 33
5.12.3 User Arm Options
The User Codes can be programmed as the following:
Disarm/Arm: The code will arm and disarm the PCX system (Default)
Disarm Only: The code will only disarm the PCX system once it is fully armed.
Arm Only: The code will only arm the PCX system.
None: The code will not be used to arm and disarm the system.
5.12.4 Flexi Arm
If enabled, the user will be able to select which partitions they can arm/disarm, from those the code
is valid for.
If disabled, the user code will automatically arm in the selected partition(s). This option is
commonly used if a proximity tag has been used on the system. (Default for Duress Codes)
Visual Keypad Programming Procedure
CHANGE CODES
Change Codes
Using the and keys, scroll to ‘CHANGE
CODES? Press the key
5 Digit Pins
Enter : for No
Enter : for Yes (Grade 3) (Default)
Press the key
Change Duress Codes
Press the key to Change the Duress Codes,
or for the next function press the key.
NOTE: User codes can only be changed in
the user manager mode
Duress Codes
Enter the required User Number using the
numeric keys.
Press the key
If a code or tag is already allocated, the display
will show [******]. Enter the new code, or
present a tag to keypad. To erase the existing
code press the F key. Press the key