Installation manual

PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 27
The controller provides ‘Alarm’ and ‘Can Set’ outputs dedicated to that sub-partition. It also
provides relevant indications, including Set/Unset status, so should always be located adjacent to
the controlling Keyswitch where this is used.
If the option ‘Auto Readmits when set’ is selected as ‘WHEN AREA SET’ then the sub-partition will
always set when the area in which it located is set. If selected as ‘NEVER’
it will always require
manual setting.
The sub-partition must ALWAYS
be unset manually.
An additional option is available the ‘SITE OPTIONS’ menu, to permit a ‘misoperation’ (abort)
signal to be generated by silencing an alarm at the Controller.
Operation of a sub-partition
Action Status Notes
Normal (unset) status
Detectors within sub-
partitions are inactive
‘Unset’ indication lit
Sub-partitions input triggered No response
Attempt to set sub-partitions
with input in fault
-
‘Fault’ LED flashes and
intermittent tone to
indicate ‘cannot set’
Set sub-partition with no faults
sub-partition sets (detectors
live)
‘Unset’ indication goes out
Sub-partition input triggered Alarm generated
‘Alarm’ LED lights, alarm
tone generated
Sub-partition Controller unset sub-partition unsets ‘Unset’ indication lights
Valid code entered at a
Keypad whilst alarm running
Alarm silenced Sub-partition remains set.
Visual Keypad Programming Procedure
ASSIGN KEYPADS/READERS
Sub Partition Control
Assign Keypads/Readers
Using the and keys, scroll to ‘ASSIGN
KEYPADS/READERS?’
Press the key
Address
Enter the address of the keypad/reader you wish
to assign. Press the key
Type
Enter : for Reader
Press the key