Installation manual

PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 15
5.4 Choose Mode
5.4.1 The End of Line Range
This programs the panel to operate with different resistor values:
1K = Alarm: 1K, Tamper: 1K. 2K2 = Alarm: 4K7, Tamper: 2K2. 4K7 = Alarm: 4K7, Tamper: 4K7
5.4.2 SEOL or DEOL
This programs whether the whole alarm panel and any Remote Input Expanders will be used in
Singe End of Line (SEOL) or Double End of Line (DEOL) resistor mode.
5.4.3 Input Response Time
This selects the time that a input trigger must be present before the whole system responds by
generating an alarm, and is programmable from 100ms (0.1 seconds) to 3000ms (3 seconds).
Note:
Settings above 400mS do not comply with PD6662/EN50131. If used in a BS4737
installation, setting should be between 300 and 800mS.
5.4.4 Input XDF
DO NOT CHANGE THIS SETTING UNLESS INSTRUCTED TO BY CUSTOMER SUPPORT.
Visual Keypad Programming Procedure
CHOOSE MODE
Choose Mode
Using the and keys, scroll to ‘CHOOSE
MODE?’. Press the key
The End of Line Range
Enter : 1K. Enter : 2K2
Enter : 4K7. (Default)
Press the key
The End of Line Mode
Enter : for SEOL
Enter : for DEOL (Default)
Press the key
The Input Response
Select the required input response – using
(100ms) all the way to
(3000ms).
Default (400ms). Press . ‘Input XDF will be
displayed, do not alter this and press 