Installation manual

PCX 256 PROGRAMMING MANUAL
RINS868-6 Page: 11
4.7 Arm / Disarm System
If you do not have access to a user code, arming and disarming the system can be done using the
engineer’s code.
Visual Keypad Programming Procedure
ARM / DISARM SYSTEM
¾ Enter the Engineer Code (default 9999).
¾ “ARM / DISARM SYSTEM?” will be
displayed
¾ Press the key
Select the partition(s) / level arm you would like
to arm. Press the key. The system then will
begin to arm. To disarm the partitions, enter the
engineer code, and wait a couple of seconds.
‘ARM/DISARM SYSTEM’ will be displayed,
press the . To disarm the partitions, press
the key.