Manual

1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
Upper
Display
Lower
Display
When Visible Description
SP Value
-)
Display strategy 1, 3,
4, 5 and 6 if Digital
Input is not
=-7 in
config mode and
RSP is not used.
Target value of Setpoint.
Adjustable except in Strategy 6
SP1 Value
-)
or
:-)
Display strategies 1
to 6, if Digital Input is
set for dual SP
(
=-7 in config
mode).
Target value of Setpoint 1.
:-) means
SP1 is selected as the active Setpoint.
Adjustable except in Strategy 6
SP2 Value
-)
or
:-)
Display strategies 1
to 6, if Digital Input is
set for dual SP
(
=-7 in config
mode).
Target value of Setpoint 2.
:-) means
SP2 is selected as the active Setpoint.
Adjustable except in Strategy 6
Local Setpoint
Value
'-)
:'-)
or
*'-)
If Remote Setpoint
Input is fitted and
Digital Input is not
=-7 in config
mode
Target value of Local Setpoint.
:'-)
means the local setpoint is selected as the
active SP (if the digital input has been
overridden, the _* character is lit instead).
Adjustable except in Strategy 6
Remote
Setpoint
Value
+-)
:+-)
or
*+-)
Target value of Remote Setpoint.
:+-)
means the remote setpoint is selected as
the active SP (if the digital input has been
overridden, the _* character is lit instead).
Read only
Valve Position
Value
)xxx
Display strategy 7 if
position indication
enabled () or
) = )C)
The valve position as read by the Auxiliary
Input. Position is expressed as a
percentage from
) (fully closed) to
) (fully opened).
__'-)
+-)
or
=#
-)-
If Remote Setpoint
Input is fitted, Digital
Input is not
=-7 in
config mode and
-- C is enabled in
Setup mode
Setpoint Select. Selects between Local or
Remote Setpoints.
'-) = local SP, +-) = remote SP, =#
= selection via digital input (if configured).
Note:
'-) or +-) will override the digital
input (active SP indication changes to
*)
Adjustable except in Strategy 6
Actual SP
Value
-)+)
If a Ramping
Setpoint is in use
(
+) not Blank).
Actual value of selected Setpoint (e.g.
ramping SP value). Read only
SP Ramp
Rate Value
+)
If -@+ (ramping SP)
is enabled in Setup
mode.
Setpoint ramping rate, in units per hour.
Set to Blank (higher than ) to turn off
ramping. Adjustable except in Strategy 6

If
is fitted and
Digital Input is not
=-7 in config
mode
Remote Setpoint
Input
59305, Issue 6 – March 2006 P6170, P8170 & P4170 Model Group Page 77