User guide

MCS 3x series controller set-up User Guide : MCS-3800 Control Mapping
Page 7
If no MIDI driver is installed, the MIDI Input and MIDI Output combo-box dropdown menus will be empty and
the A device ID has been used that is out of range for your system error message will be displayed when either
the Apply Changes to Controller button is clicked or the OK button is clicked to close the Pyramix Settings dia-
log:
Enable
Each installed hardware controller can be enabled or disabled with the Enable checkbox in the Controller prop-
erties dialog.
Make sure the Enable checkbox is ticked before clicking on OK to close the dialog.
Removing an Installed Controller
Highlight the controller you wish to remove in the The following controllers are installed: list by clicking on it
then click on the Remove button:
MCS-3800 Control Mapping
MCS-3800 mapping allows for user defined custom configurations. A wide range of Pyramix controls and audio
effect parameters can be mapped to the MCS-3800 hardware surface controls. To configure the mapping, go to
MIDI Warning Info
Controller Properties dialog
All Settings > Remote Control > Controllers