User guide

MCS 3x series controller set-up User Guide : Introduction
Page 5
Introduction
Overview
This document details the physical and logical connections required to enable JL Cooper MCS 3x series hardware
control surfaces to control Pyramix Virtual Studio using the optional Remote Control MIDI protocol.
Scope
The JL Cooper Controllers are supported by the Optional Pyramix MIDI Remote Control Protocol feature.
In Pyramix the following MCS series devices are supported:
MCS-3800
MCS-3000
MCS-Bridge
MCS-3000x
For more information on installing and using the MCS family controllers, please consult the MCS-3000 Series User
Reference Manuals.
Setup
Requirements:
Components required for operating a JL Cooper MCS Controller with Pyramix:
• A supported JL Cooper MCS series controller.
• Pyramix 5.0 or higher with the Remote Control MIDI Protocol option authorized.
• The PC Workstation running Pyramix must be equipped with a functioning MIDI interface.
Communication
Pyramix and the DM-2000 communicate via MIDI.
Connections
MIDI
Connecting the controller requires that a hardware device with MIDI port functionality be installed in the com-
puter. An external USB to MIDI interface will also work fine, or a soundcard with MIDI I/O, e.g. a SoundBlaster.
All subsequent set-up information assumes that the MCS controller is properly powered and connected to a func-
tioning MIDI interface.
Adding an MCS Controller
Before the MCS control surface can be used or the controls mapped it must be “added” in Pyramix and the correct
driver selected.