User Guide

REPLACING RIBBON CARTRIDGE
AUTO TOTALING TIME CLOCK INSTRUCTIONS
Model 3800
13pyramidtimesystems.com
Use only genuine Pyramid product part #43079 Replacement Ink Ribbon Cartridge.
Unlock and remove the time clock cover.
Prior to removing old ribbon, slide “SET” switch to the right.
CAUTION: Do not
attempt to change the ribbon when in operation mode, as this may result in injury.
To remove old ribbon, pull two clips towards you and simultaneously lift ribbon
cartridge, pull straight up using tab located on top of cartridge.
Remove new ribbon cartridge from packaging and turn the manual ribbon advance
knob clockwise to straighten ribbon.
Holding tab install ribbon cartridge into print carriage, making certain to
lower the ribbon in front of the ribbon guide rst, then make certain
retaining pins are within clips (see diagram).
Gently push down cartridge until it snaps into carriage while turning the manual
ribbon advance knob clockwise.
Turn manual ribbon advance knob clockwise a few rotations to ensure ribbon is
positioned correctly in front of print head.
Slide “SET” switch to the left.
Replace the cover and lock unit.
Feed a time card through unit to test print quality.
REPLACING RIBBON CARTRIDGE
1
2
3
4
5
6
7
8
9
B
B
E
D
C
C
F
A – Ribbon Cartridge C – Tab E - Manual Advance Knob
B – Clips D – Ribbon Guide F – Retaining Pins
For optimum performance, replace ribbon cartridge every 6 months.
A
B
D
E
C
F
10
11