User Guide
AUTO TOTALING TIME CLOCK INSTRUCTIONS
Model 3800
10 PROGRAMMING 888.479.7264
CHANGING A SET
Slide the “SET” switch to right.
In SET mode, press “ENTER” to select the SET mode to be changed.
Follow the instructions for the selected feature.
Slide the “SET” switch to the left when complete.
4
2
3
1
CHANGING A SET MODE
This feature sets the number of hours allowed between punches to
guard against employees who forget to punch out. For example, if 13
hours is selected, an employee punches in, forgets to punch out,
the clock prints the next line as an “In punch” if more than 13 hours
have elapsed. The time card will show the “In” punch followed below
by a space where the “Out” punch
would have been located and then
followed by the correct “In” punch.
Hours can be set from 00-99.
The default is set at 13 hours.
12-SET MAXIMUM NUMBER OF HOURS ALLOWED BETWEEN IN/OUT PUNCHES
This function enables you to choose the number of hours that take
place before the daily time is considered overtime. The default
SET is 08:00.
In SET mode, press “+” or “-” to select the hour.
Press “ENTER” to conrm.
In SET mode, press “+” or “-” to select the minutes.
Press “ENTER” to conrm.
The SET advances to “12”.
Continue to next steps or slide the “SET” switch to the left to exit SET mode.
2
3
1
11-SET DAILY OVERTIME (OT start line)
4
5
6
In SET mode, press “+” or “-” to select the hour.
Press “ENTER” to conrm.
Slide “SET” switch to the left to exit SET mode.
2
3
1