User manual

Quick Start 4-11

• Select the Output tab. The Output mapping screen is displayed. The top

portion gives a list of the devices in the scan list that the BridgeWay will

send output data to. The bottom shows the location in the Output table

where the data will be placed for each device. This shows the format of

the Output table of the BridgeWay. This is the format of the output

data that will be sent to the BridgeWay from the EtherNet/IP scan-

ner. See “I/O Mapping” on page 3-8

• Click the Apply button, and Yes to download the scanlist to the Bridge-

Way.

• The BridgeWay starts scanning as soon as it finds entries in its scanlist.

However, in Idle mode, output data will not be sent to the devices.

Note: Automap is used in this example for simplicity. In some cases, the user may

wish to organize the I/O data in other ways; this can be done using the Advanced

data table editor in the Input and Output tabs. See the RSNetWorx manual for

complete details.