User manual

Quick Start 4-9

Step 6: Configuring the Other Options

The remaining DeviceNet configuration parameters are set through the parameter

editor in NetTool-DN-D. (See the explanation of these parameters in “DeviceNet

I/O Configuration” on page 3-17.)

• Highlight the BridgeWay module by right clicking with the cursor on its

icon.

• Select the Device menu option and pull down menu, then select Proper-

ties. A parameter screen is displayed.

• Click on Upload. The parameter values will be read from the device.

• The Baud Rate, Autobaud, and I/O Byte Swapping and Input Safe State

parameters can be set by clicking on each parameter and selecting the

desired value from the drop down box.

• Click Download to send the changes to the BridgeWay.

• Click Close.

Note: Changes to the DeviceNet configuration parameters do not take effect until

the module has been power cycled.

Note: If the BridgeWay is the only master on the DeviceNet network, DO NOT

enable autobaud. Automatic baud detection requires there to be traffic on the net-

work, there is typically no traffic until the master establishes connections.